Raymarine GyroPlus Yaw Sensor Průvodce nastavením Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 38
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Chapter 3: Troubleshooting & Maintenance 23
3.2 Maintenance
Important
Before attempting any maintenance procedure on the SPX-5R Drive system, ensure
the boat is securely moored alongside and that power to all system components is
switched off.
CAUTION: Avoid damage when cleaning
Do NOT use solvent or abrasive cleaners on any SPX-5R Drive system
components.
Spare parts
CAUTION: Do not dismantle SPX-5R Drive system products
The SPX-5R Drive system does not contain any user serviceable
parts other than those specified below, and so should be serviced
only by authorized Raymarine service technicians.
The only user-replacable components in the SPX-5R Drive system are the Course
Computer fuses, and these are available from your Raymarine dealer:
Fuse F1 - 15 A (power in fuse). Part number 15454.
Fuse F2 - 2 A (SeaTalk fuse). Part number 15455.
If any other parts require servicing or replacement, please contact your Raymarine
authorized service agent.
NO DATA
Caused by any of the following situations:
• the compass is not connected
• the SPX-5R Drive system is in Track mode and:
• is not receiving navigation data, or
• the position sensor (GPS) is receiving a low strength signal – prob-
lem will clear when the signal improves
Check connections to the compass and navigator.
Note: The SPX-5R Drive system stops adjusting the heading as soon
as it loses data.
NO PILOT
The Pilot Controller is not receiving data from the SPX-5R Drive sys-
tem computer. Check connections and check the Course Computer is
switched on.
NO RUDREF
Only applicable if rudder reference option is fitted. Possible fault with
rudder position sensor – check connections.
RG FAIL
GyroPlus yaw sensor has failed. Call a Raymarine service agent.
NO SPD
No speed data.
NO COMP
No compass data.
NO WIND
No wind data.
SEATALK
and
FAIL
The Pilot Controller cannot transmit data to the SeaTalk system.
Make sure all SeaTalk cables are connected properly.
Alarm message Possible cause and remedy
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Komentáře k této Příručce

Žádné komentáře