Raymarine ST40 Bidata Specifikace

ST40 WindInstrumentOwner’sHandbookDocument number: 81160_3Date: 1st May 2001160_3cov.p65 01/05/01, 16:141

2 ST40 Wind Instrument Owner’s HandbookNORMAL OPERATIONApparentwindD4753-2Note: The High wind speed alarm screen is availableonly on master instrument

Chapter 1: Operation3Backlighting and contrast adjustmentDuring normal operation, pressDuring normal operation, pressThe current backlighting level is

4 ST40 Wind Instrument Owner’s Handbook1.3 Screen descriptionsApparent and true wind screensIf apparent wind information is displayed, bearing as the

Chapter 1: Operation5Indications D4754-2WINDST40 True windIf boat speed information is available at the ST40 Wind instrument(from a SeaTalk bus), the

6 ST40 Wind Instrument Owner’s Handbook160_3c01.p65 01/05/01, 16:156

Chapter 2: Maintenance and Fault Finding7Chapter 2: Maintenance and Fault Finding2.1 MaintenanceServicing and safety• Raymarine equipment should be se

8 ST40 Wind Instrument Owner’s HandbookPeriodically clean your ST40 instrument with a soft damp cloth. DoNOT use chemical or abrasive materials to cle

Chapter 2: Maintenance and Fault Finding9ActionCheck fuse/circuit breaker.Check power supply.Check SeaTalk cabling andconnector security.D4756-2WINDST

10 ST40 Wind Instrument Owner’s HandbookAssistanceIf you are unable to rectify any problem, please contact your localRaymarine Dealer for assistance.1

Chapter 3: Installation11Chapter 3: InstallationThis chapter describes how to install the ST40 Wind instrument, andassociated Rotavecta wind transduce

Copyright © Raymarine Limited 2001160_3cov.p65 01/05/01, 16:142

12 ST40 Wind Instrument Owner’s Handbook• The equipment is supplied from a different battery from that used forengine start. Voltage drops below 10 V

Chapter 3: Installation1357 mm(2.25 in)D4643-34 mm(5/32 inch)2.5 mm(1/10 inch)Note: If you intend fitting a nonstandard transducer, extra tools maybe

14 ST40 Wind Instrument Owner’s HandbookCAUTION:The presence of moisture at the rear of the instrument could causedamage either by entering the instru

Chapter 3: Installation15Clamp screwsGasketAdaptorpiecesGrub screwRail diameter 23 mm (0.9 inch) or more butless than 25 mm (1.0 inch), use adaptor pi

16 ST40 Wind Instrument Owner’s HandbookConnections to the instrumentYou can connect your instrument:• Directly to the Rotavecta, transducer as a stan

Chapter 3: Installation17Stand-alone connectionsCAUTIONEnsure that the power supply for each stand-alone ST40instrument is protected by a 3 A fuse or

18 ST40 Wind Instrument Owner’s HandbookSeaTalk connectionsCAUTIONWhen instruments are connected to SeaTalk, ensure that thepower supply for the SeaTa

Chapter 3: Installation192 Cut hole57 mm (2.25 in) cutterD4760-1Peel protective sheets from gasket3D4770-14 Stick gasket to rear of instrumentD4761-11

20 ST40 Wind Instrument Owner’s HandbookD4819-15 Screw stud into instrumentD4818-16 Feed cables through clamping bracket,connect cables then secure in

Chapter 3: Installation21D4646-1To bracket mount your ST40 instrument, do so in accordance with theInstruction Sheet, which is included with the Deskt

PrefaceiImportant informationWARNINGAlthough your ST40 instrument is designed to give accurate andreliable performance, it should serve only as an aid

22 ST40 Wind Instrument Owner’s Handbook160_3c03 .p65 01/05/01, 16:1622

Chapter 4: Calibration23Chapter 4: Calibration4.1 IntroductionThe procedures in this Chapter must be carried out before theequipment is used operatio

24 ST40 Wind Instrument Owner’s HandbookUSER CALIBRATIONEntryscreenSet wind angleresponsefor approximately 2 secondshold down and15 (fast)1 (slow)D476

Chapter 4: Calibration254.3 Intermediate calibrationIntermediate calibration enables you to:• Check the instrument software version.• Check the instru

26 ST40 Wind Instrument Owner’s HandbookCAUTION:Do NOT switch the Boat Show mode on.This function must only be used fordemonstration purposes.To save

Instrument Specification27Instrument SpecificationSupply voltage: 10 V dc to 16 V dc.Current consumption (12 V supply): 25 mA typical.60 mA with maxim

28ST40 Wind Instrument Owner’s Handbook160_3spe.p65 01/05/01, 16:1628

Glossary29GlossaryEMC Electromagnetic compatibility.KTS Knots.M Metres.M/S Metres per second.Response The rate at which an instrument responds to chan

30ST40 Wind Instrument Owner’s Handbook160_3glo.p65 01/05/01, 16:1630

Index31IndexAAlarmenable/disable 5indications 5range 27setting level 2silencing 1Align transducer 24Apparent wind speed 2Apparent/true wind screen 4BB

ii ST40 Wind Instrument Owner’s Handbook160_3pre.p65 01/05/01, 16:142

32 ST40 Wind Instrument Owner’s HandbookLLinearising transducer 24Locked apparent wind screen 4Locked wind angleauto lock 2manual setting 2Low battery

D4800-1TOPCut outshaded area onlyCut out hole57 mm (2.25 in)diameterST40 Instrument Template160_3tem.p65 01/05/01, 16:1633

160_3tem.p65 01/05/01, 16:1634

Document number: 84064-8April 2001Limited Warranty CertificateRaymarine warrants each new Light Marine/Dealer Distributor Product to be of good materi

Factory Service CentersUnited States of America UK, Europe, Middle East, Far EastRaymarine Inc22 Cotton Road, Unit DNashua, NH 03063-4219

PrefaceiiiContentsImportant information ... iWARNING...

iv ST40 Wind Instrument Owner’s HandbookChapter 3: Installation... 113.1 Planning your installat

PrefacevPrefaceThank you for purchasing a Raymarine product. We are sure yourST40 instrument will give you many years of trouble-free operation.This i

vi ST40 Wind Instrument Owner’s HandbookParts suppliedRotavecta wind transducerD4752-3ST40 WindInstrumentOwner'sHandbookWorldwideDistributorsST40

Chapter 1: Operation1Chapter 1: Operation1.1 IntroductionYour ST40 Wind instrument:• Provides apparent wind speed and direction information. Windspeed