Raymarine DS500 Specifikace stáhnout pdf (Strana 23)

Chapter 2: Installation 13

2.6 System Connections

The rear of the display unit provides the following connection sockets:

• Transducer connection.

• Power, for 12 VDC power connection and NMEA connection.

Figure 2-5: DS400/500 Connector Panel

The following sections detail the connectors used when installing the

DS400/500.

DC Power Connection

The DS400/500 is intended for use on the boat’s DC power systems rated

from 10-18 Volts DC (13.8V nominal).

The power connection to the unit should be made at either the output of the

battery isolator switch, or at a DC power distribution panel. Raymarine

recommends that power is fed directly to the DS400/500 via its own

dedicated cable system.

A 2 amp, fast blow fuse is attached (in-line) to the red (positive) wire.

A 5 ft (1.5 m) Power/NMEA cable is supplied for connecting the boat’s DC

power to the unit. The Power/NMEA cable may be extended by up to 60 ft

(20 m) using a wire gauge of AWG 12 or greater.

DC power is connected at the seven-pin Power/NMEA connector on the

unit’s connector panel. The connector (viewed from the outside) and pin

functions are shown in the following diagram and table.

D6459-1

Power/NMEATransducer

D6462-1

pin1

bereitgestellt von Busse-Yachtshop.de

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 95 96

Žádné komentáře

Raymarine DS500 Specifikace Strana 23