Raymarine ST60 Specifikace Strana 17

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 52
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 16
Chapter 1: Operation 5
Once you have selected the required timer display, press the reset key to start the
timer running. When a timer is running, the delimiter (i.e. .or :) flashes. For lap
timing, press the
reset key. To stop and reset a timer to the start value, hold down
the
reset key for 1 second.
Once a timer is running, you can leave the timer page and select any other display.
The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15 minutes.
Note:
When the instrument is first installed, the race-start timers are set to 4 and 5 min-
utes respectively.
To set a race-start timer:
1. Use the
timer key as shown in the
Using timer key
flow diagram to select the
required race-start timer.
2. Simultaneously press the
timer and reset keys to enter the race-start timer
adjust mode.
3. Use either the
timer or reset key to set the required value.
4. Simultaneously press the
timer and reset keys to save the value and leave
the race-start timer adjust mode.
If you are using one of the race-start timers and the timer buzzer is enabled, the
buzzer will:
Double-beep every minute.
Beep three times at the start of the last 30 seconds.
Beep once for each of the last 10 seconds.
Beep for 2 seconds at zero.
The timer buzzer is enabled or disabled as part of the calibration procedure (see
Chapter 4, Calibration
).
Note:
After a race-start timer has counted-down to zero, it will then start counting up.
1.3 Display settings
Illumination
When the instrument is first powered up, the display illumination is set to its
lowest (courtesy) level to facilitate initial access to the keys. To adjust the level of
illumination:
1. Hold down the speed key for approximately one second, to enter the illumina-
tion-adjust mode.
Zobrazit stránku 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Komentáře k této Příručce

Žádné komentáře