Raymarine SmartPilot SPX-30 Instalační manuál stáhnout pdf (Strana 13)

Chapter 2: Commissioning procedures 5

Chapter 2: Commissioning procedures

This chapter will guide you through the commissioning process for an SmartPilot X

system. It includes:

• Initial setup.

• Dockside calibration.

• Seatrial calibration.

The ST70 Autopilot Controller has an initial setup and calibration wizard, which will

take you through the commissioning process. Your autopilot will select the setup

screens relevant to your system. Those that are not relevant will be skipped

automatically.

Note: If you already have an ST70 instrument installed, some settings will be automatically

transferred from that and the wizard will skip those settings.

2.1 Switching on and initial setup

With the boat safely tied up, use these initial setup instructions to switch on the

autopilot system and controller, and to carry out the following initial setup procedures:

• Select language.

• Set boat type.

• Set date and time format (only if GPS is fitted).

• Set correct local time (only if GPS is not fitted).

• Set required data units.

Note: In order to carry out calibration procedures you must complete initial setup.

If the system has previously been set up and calibrated this part of the setup wizard

will not be displayed and you can continue immediately with dockside calibration.

WARNING: Calibration requirement

All autopilot systems must be calibrated before use.

81287_1.book Page 5 Tuesday, March 18, 2008 11:50 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Žádné komentáře

Raymarine SmartPilot SPX-30 Instalační manuál Strana 13