Raymarine SmartPilot SPX-30 Instalační manuál stáhnout pdf (Strana 32)

3.4 Sailboat settings

These settings are only applicable to sailboats

AutoTack

The Auto Tack Angle feature allows you to specify the angle through which the vessel

will tack when you select Auto Tack. When in Wind Vane mode, this will match

Apparent Wind Angle.

1. Press

, then use < and > to scroll to Autopilot Calibration and press

ENTER

2. Use < and > to scroll to

Vessel Settings

and press

ENTER

3. Use < and > to scroll to

Sailboat Settings

and press

ENTER

4. Use < and > to scroll to

Auto Tack Angle

and

press

ENTER

5. Use < and > to increase or decrease the auto

tack angle.

6. Press

ENTER

to accept the change or

CANCEL

to exit without making any changes.

Gybe inhibit

With gybe inhibit on, to prevent accidental gybes, the SmartPilot will prevent the boat

from performing an AutoTack away from the wind

With gybe inhibit off, you can perform an AutoTack into or away from the wind. See

also AutoTack on page 24.

1. Press

, then use < and > to scroll to

Autopilot Calibration and press

ENTER

2. Use < and > to scroll to

Vessel Settings

and

press

ENTER

3. Use < and > to scroll to

Sailboat Settings

and

press

ENTER

4. Use < and > to scroll to

Gybe Inhibit

and press

ENTER

5. Use < and > to enable or disable gybe inhibit.

6. Press

ENTER

to accept the change or

CANCEL

to exit without making any

changes.

Press ENTER to select.

Auto Tack Angle

D10860-1

Auto Tack sets the angle that the

vessel will tack through.

Press ENTER to select.

Gybe Inhibit

D10856-1

Stops an accidental gybe.

Disable

81287_1.book Page 24 Tuesday, March 18, 2008 11:50 AM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Raymarine SmartPilot SPX-30 Instalační manuál Strana 32

Komentáře k této Příručce